the Wall mounted Mask Holder.

I've been Designing masks for a few months now and I do not care to much for the hooks I bought to hold my mask on the wall, how it would stretch out the headband with the weight of the mask being held by the hook. So, I designed a wall mount that holds the mask snug to the wall from the holes of the mask instead of the strap to hold it by a hook.

• It prints in 4 pieces, the base, 2 hooks and the bar 
• the hooks are able to slide in or out to accommodate the size of the mask width
• I put filament sized holes on the end of the bar to lock hooks in if wanted, work the holes on the outsides just enough so the filament can slide through and cut leavening just enough for the hooks to no slide off. You do not need to do this just an added feature if you wanted to lock then on the bar. check pics to see what to do.
• on the back of the base, I put a cut out for a command strip not sure if the single double-sided strip is thick enough, I did not have any, but I like to use the Velcro ones and had those on hand so they will fit those for sure. sized for the medium sized ones but can cut down larger ones to fit if needed.
• the hooks are an inch in length, so you have plenty of hole space to grab onto. it is 5mm high on the arm and 7mm at the end nub, and 3mm thick, so it can fit in any hole in your mask that small. It fits all of my masks except for the holes in my beard mask.
• It is a quick easy print and light on filament only 31G
• I will have a separate profile for the A1 mini they parts needed to be arranged differently to fit on the plate
• the bar has a width of 215 mm just under 9 inches in width so plenty of room to go outwards
• hooks are nice and sturdy should hold the weight of a mask no problem