N3D Poke ball Stand - Healing / Charging Station

As in the game I have created a large print based on the healing station and it can hold 6 different N3D Poke balls on it. The Character balls may fit but not all models will due to wings, tails etc.

Please be aware that this is a big print and uses just over 700g of Filament. When doing the the stations larger pieces that are marked grey I suggest using a new role of filament just in case you have two of the same colour but there is a slight difference in the colour between the rolls. This happened in my test print that is in the photos. 

There are 5 Plates in this model and the colours used in the test print are listed below.

Filaments 

Bambu Lab - Matte - Scarlet Red

Bambu Lab - Matte - Ivory White

Bambu Lab - Matte - Light Grey

Dimensions

Height = 112mm

Width = 270mm 

Depth = 344mm 

There has been a few chats had about this in different chats so thought I would create one and have obtained N3D permission to publish it and refer to his models.

Please see the below link for the makerworld models designed by N3D that this stand has been designed to hold..

https://makerworld.com/en/@N3DMEL

N3D has also got an Patreon page where you can find a larger variety of Pokemon Character balls available.

Patreon
Facebook

If you can give me a like that would be great.

UPDATES

V2 - Has got an additional plate where the stands within the Healing Station sit 1 cm higher. Only one plate needs to be printed.