I made a few little shovels / scoopers to fit the inner curvature of my SharpStone herb grinder that I measured at Ø47.5mm. I created a small one (3mm tall) and a slightly larger one (4mm tall) each with the curvature at the front of the blade. Then I created one additional variant with a flat front for scraping the bottom. The plate includes all 3 variants, but any of them could be printed separately, or scaled as needed. They all use less than a gram of filament each. Functionally, these little scoopers work perfectly for what I wanted to use them for.

Due to the small features, I printed this in PLA with the finest possible layer height (0.08mm), slowed the print speeds down, and and reduced the line widths. Once the bed plate is fully cooled down, they can be carefully pulled off with the help of the Bambu scraper blade to prevent damaging the part(s). The very front of the blade is only about one base layer thick, so be careful!