This is a remix that makes this plate holder usable for the X1 and P1 series printers build plates.

I also remved the m3 nuts and put m3 (Voron type - m3 x 5mm x 4mm) heat set inserts in their place.

It's a single 3mf, that contains all the needed parts spread out on 6 plates.

The “Small Parts” plate is set to “By Object” since i wanted to print the button in a different color without printing them separatly or dozens of filament changes. “Slider” and “Arm” are an assembly - this takes up less space due to the “By Object” printing on this plate in case you want to print mulitple on a single plate.

You could skip all this and set the plate to “By Layer” if you print the Slider and Arm in the same color as the Button - which i didn't.

You will need to use countersunk head screws and you may want to countersink the ones for the woodscrews just a bit more, to make them sit flush - depending on the screws you have.

If you have questions about the assembly, check out the original model.