Ornamental Cubone Skull V2 Pokemon

Copyright Claim

Ornamental Cubone Skull V2 Pokemon

Boost
317
492
51

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1

0.12mm layer, 2 walls, 12% infill
0.12mm layer, 2 walls, 12% infill
Designer
4.9 h
1 plate
4.9(51)

Boost
317
492
51
8
471
318
Released

Description

Another variation of my Ornamental cubone skull, this one has a different design added to the mesh via Zbrush.

Prints with less supports than the original.

 

Join my patreon for the right to sell physical prints https://www.patreon.com/ScatteredCollectables

 

The provided 3mf has the skull rotated onto its back, with a section cut off for a flat base, the extra piece cut off will also print, just glue it onto the back. Printing in this orientation uses less supports and gives a nicer finish compared to printing it flatter with the teeth against the plate.

The slower wall speeds are to account for the overhangs and fine details. faster wall speeds will cause rough spots around eyes and teeth

Comment & Rating (51)

Please fill in your opinion
(0/5000)

Print Profile
0.12mm layer, 2 walls, 12% infill
super clean with rain pls plus on Bambu p1p no change to the settings
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
bonito diseño, impresión sin problemas. Al imprimirse boca arriba tu e problemas para que la parte de atrás saliese lisa, aunque lo bueno es que esa parte no se ve jaja
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
came out great
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
nice looking design
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
very nice
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
looks good! The back piece could use a groove to better align and fit the two together though for a more consistent build. Additionally, I tried increasing the print size to max out my build plate, but kept experiencing failures.
0
Reply
Boosted
Print Profile
0.12mm layer, 2 walls, 12% infill
looks great and was easy to glue the back piece on
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
amazing quality
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 12% infill
0
Reply

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.