4 Tier Card Display Stand by NNLife

NNLife

Tools>Organizers

IP Report

Print Profile(2)

All

H2D

0.28mm layer, 2 walls, 15% infill

Designer

4.2 h

1 plate

5.0(2)

Top layer with groove. Does not need to lean against wall.

Designer

5.3 h

1 plate

4.0(1)

Open in Bambu Studio

Boost

Released

Description

4 tier display stand for cards, including slabs, mag cases, top loaders, etc. Top layer needs to be against a back wall to work well. Quick print and low filament need given the size. Printed several without any issues. Please share and feel free to upgrade. Share your ideas so we can improve this together for card collectors.

Comment & Rating (9)

@ThugaPT

The assembly is with glue or just "snaps on"? Thanks

The designer has replied

@user_1590396188

It will snap together. You could use glue if you’d like but not necessary in my experience

@ThugaPT

Replying to @user_1590396188 :

Thanks for the reply

@ThugaPT

Replying to @user_1590396188 :

Any way to print the version with groove on the P1S without doing two plates? When I try to change to the P1S Nozzle settings on the grooved project it says there are objects too close to the exclusion zone and that collisions might occur, am I right in concluding that the only way is to print that piece on a different plate?