Bookmark Display Frames for 50x150 Bookmarks.  

*GLUEING IS REQUIRED IF YOU WANT THEM TO STICK TOGETHER*

For 5 or More bookmarks.  How many is up to you.

Commercial License to sell my designs can be found here:

https://www.patreon.com/c/DoubleJDesigns3D

This design was inspired by a couple of great designers who made special bookmark projects with more then 4 in the set.

My 1-4 bookmark frames that match these ones, but without the thin outter edge can be found here.

https://makerworld.com/en/models/1110330#profileId-1106689

It was very important to separate the 2 sets of bookmark frames as having 5 or more do not fit on one baseplate and there needed to be a thin outer edge were the two frames meet so all the frame edges are the same size.  Combining the entire collection in one file could cause a lot of accidental misprints.  If you only need 1,2,3 or 4 frames print the original files as there are very little glue required or none at all depending how you use them.

Combine 2 LEFT with 3 RIGHT for 5

Combine 3 LEFT with 3 RIGHT for 6

Combine 3 LEFT with 4 RIGHT for 7

Combine 4 LEFT with 4 RIGHT for 8

Combine 3 LEFT, 3 Middle, 3 RIGHT for 9

For 10 or more their are many combinations.

You can do the opposite numbers say 2 RIGHT and 3 LEFT also. I included them as my OCD made me do it. :)

_____________________________

This design allows you to put your bookmarks on your wall or on a shelf and easily remove the bookmark you want to use in your latest novel adventure.  Or simply put them up on your wall for everyone to appreciate.  Quickly change them out for new ones or for different holidays.  Some frame combinations may not fit on the A1.

Simply slide the bookmark up and out the top of the bookmark and replace it with the new one.  You don't even need to remove it from the wall.  The bookmarks are secure and will not fall out (unless you try to display them upside down :))

The bookmarks are printed using supports to allow for a track that the bookmarks slide into. These are fairly easy to remove. You may have some minor issues at the bottom of each frame at first, but its an easy remove once you get the hang of it.  If some get stuck, press at the thinnest part of the tree, closest to the frame edge. This will “crack” the trees from the frame and can be more easily removed.

For wall display, 2 inserts are provided that will fit into a cut out opening at the top of the bookmark (SEE PHOTO).  One insert includes a hole for a nail and the other is to fill in the remaining cutouts.  Not all cutouts need to be filled in, most are not necessary unless your OCD is as bad as mine and you just want it to look complete.  The only ones you need are the center one or the outsides for proper balance on the wall.  PLEASE SEE ALL PHOTOS FOR REFERENCE.

Highly recommend adhesive that is made with Cyanoacrylate as it will not leave white residue on the prints after it dries.

BOOKMARKS USED IN THE PHOTOS CAN BE FOUND AT:

Check out creator CANADIAN GAMER and his great collection of bookmarks here:

https://makerworld.com/en/@CanadianGamer

His great collection of bookmarks here:

https://makerworld.com/en/collections/1424555

Thank you CG for letting me use your bookmarks in my photos!