Anutter Paper Towel Rack by PuzMaker2024

PuzMaker2024

Household>Other House Models

IP Report

GIF

Print Profile(1)

All

X1E

P1S

P1P

X1 Carbon

0.2mm layer, 2 walls, 15% infill

Designer

6.7 h

3 plates

5.0(2)

Open in Bambu Studio

Boost

Released

Description

Anutter paper towel rack with print-in-place hinge to easily change the roll. Designed to fit under a shelf or cabinet, but other configurations are possible. Tight clearance on the hinge keeps the post in place during use.

Printed in Bambu Lab PLA Matte Black as shown.

0.4 mm nozzle

0.2 mm layer height

No supports required

Printable template included for pre-drilling holes. Dimension between the posts is best determined by the installer as roll lengths vary.

Comment & Rating (7)

@user_2466056576

Boosted

Printed on X1C with 0.4 nozzle in PLA and couldn’t move the hinge part.

The designer has replied

@PuzMaker2024

Very sorry to hear that, user_x576, that can be aggravating. I went through quite a few prototypes of this thing and had few issues with the hinge. I was "breaking" them free by placing the hinge face down near the edge of the workbench and pushing down with the palms of my hands. I didn't have to put a lot of weight into it, just some firm pushes. Once broken free, operation should be tight to keep the thing in place. Once again, sorry.

@user_2466056576

Boosted

Replying to @PuzMaker2024 :

Thank you for replying, it’s much appreciated. Hopefully your solution will other makers. I’ve printed the hinge parts separately & will try to assemble some other way. Thanks for a beautiful design.