This Star Wars Fan Art was made using HueForge. It requires 4 colors, Red, Black, Gray, and White. I used some Matte colors for this print because the colors seem to blend well together. Matte also helps reduce stringing on the print, but you can use normal PLA if that is all you have. Please keep in mind depending on the brand and shade of your PLA your results may vary.

Print at 100% infill with a layer height of 0.08, the first layer needs to be 0.16, and a wall loop of 1.

I did not use a prime tower, it is not needed. This print should take about 1h54m if you use the 3mf settings.

Happy Printing!!

The Model is 143.31x200mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 1.4mm

This print uses 4 unique filaments

Filaments Used:
    PLA PolyLite Wine Red Transmission Distance: 1
    PLA Sunlu Black Transmission Distance: 0.3
    PLA Sunlu Gray Transmission Distance: 5
    PLA Sunlu Matte White Transmission Distance: 5
 

Swap Instructions:
    Start with Wine Red
    At layer #5 (0.48mm) swap to Black
    At layer #7 (0.64mm) swap to Gray
    At layer #12 (1.04mm) swap to White for the rest.