Suspended Heart

eZaFs

Household>Decor

IP Report

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

H2D

0.2mm layer, 2 walls, 15% infill - Arachne ON

Designer

2.1 h

1 plate

3.8(10)

Open in Bambu Studio

Boost

Released

Description

Here's yet another suspended model! I'm a bit addicted to making these things…

If you're a fan, check out my other suspended models - Suspended Embrace and A Floating Embrace

As I mentioned with my other suspended models:

I would highly recommend using the profile I've made. This can be a somewhat challenging print if the settings aren't just right.

If you do slice on your own, make sure that Arachne Wall generator is turned on.

DO NOT SCALE

Feel free to post your makes! Love to see my designs come to life.

Boost Me (for free)

And of course... Boosts are greatly appreciated.

Comment & Rating (15)

@user_1811856194

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

Sehr schönes Modell.

@BLFanForLife

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

So cool! Thanks for sharing! When removing it, don't forget to ensure that the heart is also free-floating. I got too excited and broke 3 of the 5 supports. Fortunately, the two that are left are on top! Go slow and enjoy the work of art!

@NeoTrace

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

printed beautifully, unfortunatly i think 6 strings are a bit to few was very carefully but one was allready loose, bottem right

@Ditorious

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

Support Issue:looks amazing but the supports snapped before print finished.

Strength Issue: too few supports during print. could be a print speed issue on my end

@myoung10765

It came out perfect but the strings broke as soon as I tried to pull it from the plate after cool down.

The designer has replied

@eZaFs

Ahhh, thats no good. I had success with very gently taking the plate off, flexing it, then gingerly making sure the frame was free then making sure the heart was free.

@myoung10765

Replying to @eZaFs :

Thank you I will try again.

@user_1335368073

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

wasn’t strong enough to hold heart

@user_363230905

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

Printing problems

Show original

@user_3325065423

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

Top

@user_92042493

Even though I select the "A1" profile upon slicing it says it is for the P1P, is this supposed to be that way?

@DirtyReverie

Print Profile

0.2mm layer, 2 walls, 15% infill - Arachne ON

Support Issue:6 strings does not seem to be enough. 2 of the 6 broke just removing the plate off of the printer after it had already cooled.

The profile uploader has replied

@eZaFs

Did you try to remove it in one piece or did you make sure both pieces were loose before removing? if you wait for the build plate to cool down, completely remove the plate, flex it, make sure the outside piece is free, then gingerly make sure the inside piece is free. Should come off pretty easy. but if you just try to remove it in one piece, obviously it's gonna break