Atari Fujinet v1.3 Enclosure
IP Report
Atari Fujinet v1.3 Enclosure
Boost
1
1
0
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
48 min
1 plate
Open in Bambu Studio
Boost
1
1
0
0
0
0
Released
Description
A replacement enclosure for the Atari FujiNet v1.3 PCB.
The original enclosure felt a little bulk and had sharp corners, so I designed a replacement. Profile is setup for PLA metal, but also prints well with PLA basic. I printed in Iridium Gold, but only because I ran out of Iron Gray.
Boost Me (for free)
If you're into retro computing too, please consider boosting!
Bill of Materials
Bambu Filaments
Buy Now
Download BOM
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)