Print Profile(2)
0.2mm layer, 2 walls, 65% infill
Designer
1 h
1 plate
0.2mm layer, 2 walls, 65% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
22
21
0
0
8
6
Released
Description
Print the heart-shaped bag hanger using ABS or PTEG filament (ABS recommended).
Heart-shaped bag hanger settings:
- Sparse infill density 65%
- Support
The bag hanger can be adjusted.
Note!!!
After printing, remove the support, gently bend the joints and hold the places marked with arrows with your thumb (in the photo).
The file called Anti-slip pad should be printed using TPU Shore 20D filament and glued (preferably with cyanoacrylate glue).
P.S.
I did not do load tests.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)