Easter Eggs Decoration Decor House

IP Report

Easter Eggs Decoration Decor House

Boost
112
198
11
This model is created by Image to Keychain
Make Your Model

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
4.6(9)

Open in Bambu Studio
Boost
112
198
11
13
155
107
Released

Description

A few Easter egg designs 8x5 cm
Happy printing!
Show off your print in the comments!

Comment & Rating (11)

(0/5000)

Boosted
Good for upcoming easter
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fast, clean, beautiful! Thank you very much.
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:did not hold at all. only pushed around
Bed Adhesion Issue:did not work at all. only caused chaos. Tried three times
Show original
0
Reply
The issue isn't the print profile, but perhaps a greasy print bed? Did you use IPA or adhesive to secure the print before printing? I've printed it multiple times, yet this problem hasn't occurred
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.