Pocket Hole Cap (Kreg)
IP Report
Pocket Hole Cap (Kreg)
Boost
6
11
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
Open in Bambu Studio
Boost
6
11
1
1
4
3
Released
Description
Made these pocket hole caps/plugs based on the official Kreg brand wood ones. I modelled these a tiny bit shorter since the official ones don't fit as nicely on 1 inch wood.
No supports needed. A single plug uses 1g of filament and only takes about 5 minutes (not including calibration time). Use the .blend or STL file as you like to modify for your own use.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)