so I'm trying to print this mask and all of a sudden it's starts printing in the air like a couple of inches above where it's already printed. why would it do that??

After two failed prints, my fault because I wanted to shorten the printing time, the third print was printed on the recommended settings. I printed on rainbow filament from Sunlu but there were small imperfections, I don't know what parameters to use for this filament, but I like it, my daughter is happy, she will have a mask for a play at kindergarten.

I don't know how to gives a rating on this. There's no prompt. But anyway I would rate it at 4 right now. It's a beautiful mask but it really came out rough around the edges. It's like there a little nicks and chips out of the edges. I see one on a photo that someone else posted here, also. and the lines on the surface of the mask are just not clean. My daughter suggested that I print it at 0.08 thickness and said it will make a difference on all of the curved lines, both on the face and around the edges. if you have other suggestions, please let me know. I'm going to try 0.08 because I think it's just a beautiful mask. And I love the little loops on the back for a strap. I haven't seen those before and it looks so nice that way instead of holes in the sides.

Printed great. no issues

great easy print