Diamond Painting Boat 12cm x 7cm in Two Versions with Magnet Insert

My wife found standard diamond painting boats too monotonous, so I had to create something myself :)

The file provides two plates, depending on your text preference, essentially mirrored versions.

This depends on your painting hand and your desired placement of the Diamond inscription.

You can print the boat in various colors. Base, lines, and hull can be individually customized with color.

Suitable magnets: 10mm x 2mm

I've adjusted the 3mf file for optimal printing. Here are some additional details:

• The file uses "Arachne" wall mode. The boat and stoppers can be printed without "Arachne", but the lid should be printed with "Arachne" for best results!
• The 0.4 stopper fits perfectly by default. However, I've included 0.3 and 0.2 stoppers in .step format. These stoppers utilize variable layer height for a superior finish.
• Regarding the stoppers: If you reduce the bridging speed (external) from 50mm/s to, say, 30mm/s, the bridge will be finer, but you'll need to use the 0.3 stopper.
• Therefore, leave it as is and the 0.4 stopper fits perfectly.
• The magnet insert accommodates shrinkage to ensure the magnets fit. I have 10x2 mm magnets at home but they are actually 10.1mm x 2.1mm, so I had to adjust tolerances. More is always better, but impractical for precise models.
• Thus, there's no need for concern, the magnet insert has a tolerance of 10.4 x 2.35 mm and the magnets will easily slide in.
• I set the print speed to a maximum of 150mm/s for a good balance between quality and speed.

My 12cm x 7cm boats also fit wonderfully into my garage, which you can find on my page.

If you have any questions, just message me or leave a comment.