Spray bottle holder for Multiconnect Remixed by SprocketStudios

Remixed by

SprocketStudios

Tools>Organizers

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 3 walls, 15% infill

Designer

1.2 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Simple adaptation of JimTiffinJr's spray bottle holder for comatibility with multiconnect points.

There are two sizes - a smaller 60mm version which fits most household spray bottles, and a larger 75mm version which holds ZEP industrial spray bottles.

multiboard

multiconnect

bottle holder

Comment & Rating (3)

@pnwnerd

Print Profile

0.2mm layer, 3 walls, 15% infill

These printed fast and are quite strong. I have two of these now (IPA & Soap/Water mix) and both fit well into my Multiboard wall

@user_573857597

Printed on the A1 Mini using basic Anycubic PLA. Print went fine, finished item looks good, but the rail that is supposed to connect to the multiconnect adapter is too wide. That is, if I am using the intended adapter. You write "multiconnect point", but the link just points to the Printables start page, not a specific item. I tried with the "Multipoint" from Thangs, which is the official connector type for Multiboard. Soooo... what is it? Multipoint? Multiconnect? And if it's the latter, where do I find that?

The designer has replied