With this Holders it is now possible to mix up the 2 Version I made (Normal and Double) (Small+XL)

Please check which version you need and decide where the different boxes should be. I made a small graphic below:

One Holder can now fit: 

• 1 Double and 
• 2 Normal boxes

I made 2 Versions for the small Holder (VS1 + VS2) (with different orientations)

and 2 Versions for the XL Holder (VS1 + VS2) (with different orientations)

Tipps and values:

• Filament: PLA recommended (PETG also works)
• Quality (Layer Height): 0,2mm
• Wall Loops: 3
• Infill: 20-30% (the Handle for the organizer holder must be printed in 100% Infill)
• Infill pattern: Doesn't matter (I used Rectilinear)
• Supports: No! (Do not use supports for all of my Parts!)
• Wall generator: Classic!!!

Print the parts as they are already oriented

Please make sure that the parts come not loose while printing them. When this happens it could be that the function of my sliding mechanism does not work perfectly!

It's just a recommendation, if the parts should hold well on your plate, you don't necessarily have to use a brim.