Now you can hang up a wall clock that is inspired by the popular MoonSwatch!

The bezel and dial can be connected without screws. Simply push the two parts into each other. For the second hand, you must remove the small black pin from the Clock Kit second hand. Then push the black pin through the printed second hand.

To achieve a glowing effect on the hour markers as shown, simply use glow instead of yellow filament. 

Attention! 

To print the bezel flawlessly, you have to remove the purge line directly after calibration or disable it completely. Otherwise it will interfere with the printed object and leave a mark.

Please note that this model has been shared for non-commercial, personal use only.

Also check out my other wall clocks!

Rolex Submariner: https://makerworld.com/en/models/978569

Roles GMT-Master II: https://makerworld.com/en/models/1005310

Rolex Explorer Vintage: https://makerworld.com/en/model/1036551

Patek Philippe Nautilus: https://makerworld.com/en/models/1133027

Tudor Back Bay 58: https://makerworld.com/en/models/966249

Tudor Pelagos FXD: https://makerworld.com/en/models/907526

Mondaine Railway Clock: https://makerworld.com/en/models/1098669

If you value my work and would like to continue supporting me, you could buy me a coffee. 
Any help is appreciated!