I created a stand that will work great as well:
https://makerworld.com/en/models/1025425#profileId-1007499

This is a 5 color project. 
 

If using AMS you can assign 2 colors to the same slot. To be safe you can add a pause command to make sure you switch the filament in time. The Profile I've set up will have a pause command near the end of the orange color. I personally used the Red and Yellow for the same slot so after the red was complete and orange was printing I swapped out the red for the yellow. If someone has a hard time with this, I willing to help you out.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 147.4x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.9mm and the Actual Depth is 3mm

Filaments Used:
    PLA Basic Black Transmission Distance: 0.3
    PLA Basic Red Transmission Distance: 4
    PLA Basic Orange Transmission Distance: 7
    PLA Basic Yellow Transmission Distance: 6
    PLA Basic White Transmission Distance: 6
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #9 (0.8mm) swap to Red
    At layer #11 (0.96mm) swap to Orange
    At layer #21 (1.76mm) swap to Yellow
    At layer #24 (2mm) swap to White for the rest.