Poop Chute and Toilet Bin for X/P Series Printers
IP Report
Poop Chute and Toilet Bin for X/P Series Printers
Boost
16
31
8
Print Profile(1)
Used generic PLA profile, 0.2mm layer, 5% infill
Designer
5.3 h
1 plate
Open in Bambu Studio
Boost
16
31
8
5
37
29
Released
Description
I got tired of using filament boxes for poop collection - and other chute and bins either required screws, tape, or magnets, and then on top of that to empty - you had to remove the entire chute!!! Well not this one!
With a perfectly formed spot for the left rear foot of the printer to sit - this chute and bin is going nowhere! To make emptying the “toilet” easy, the bin slides ride out for quick and easy dumping…
Print in PLA with between 5-10% infill as you like. Tree support is needed for the toilet bin only!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)