LEG0 Minifigure Viking Shield brick

LEG0 Minifigure Viking Shield brick

Boost
45
92
3

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
5.0(1)

Open in Bambu Studio
Boost
45
92
3
2
59
41
Released

Description

LEG0 Minifigure Viking Shield brick
More: https://makerworld.com/en/collections/4440296

Comment & Rating (3)

(0/5000)

It was really difficult to remove the support from the shield. The shield ended up looking not so wonderful after using the jaws of life to remove the support. Any suggestions for a future print? Or is there a way to not make the support so snug?
The designer has replied
0
Reply
In my case, I never struggle with removing the print; I just go to the sink. I rinse it with water from all sides. Sometimes, I leave it for a moment to rest. That way, I have no trouble taking it off.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.