This Token box will work with any 15mm tokens and with 16mm dice (if you choose that version). The lid is perfect size to add a logo or design of your choice. 

Note: You need at least 5 tokens in each slot or they will fall out with movement. 

Also magnets are optional, the holes are still there if you want to use them but they aren't needed for the lid to remain secure.

The tokens I used are the ones I created:
https://makerworld.com/en/models/377722

There are 2 versions of the box

1. Box with hole: If you want to store dice, use this one. The hole allows you to push the dice out of the box from underneath. There is a seperate cover if you wan to fill this hole in and have a box that can be used both ways
2. Box without hole: This one is best if you need more room for tokens and already have a dice box. 

Bill of materials

Optional: You'll need 4mm x 2mm Neodymium disc magnets. 

How to print

If you don't want to use magnets:

Print as you normally would. Using the print profile should still pause where the magnets are meant to get inserted but just press resume.

If you want to use magnets:

Note: When the print pauses placing the magnets in their holes, just be careful with polarity. Make sure to keep an eye on them when the print resumes as the magnets can sometimes get attached to the nozzle or flicked out of their hole.

Using the print profile should still pause where the magnets need to be inserted. Place the magnets and resume. If downloading the cad files, when slicing make sure supports are turned off and add a pause on the layer just before the holes for the magnets get covered up and print. when it pauses place the magnets and resume.