I didn't like how expensive and bulky the trading card frames were on Amazon, so I designed my own! This is perfect for Pokémon, Magic: The Gathering, baseball cards, or anything you can fit into a traditional 3 x 4" toploader! It displays three cards. Just load your card into the toploader and slide the toploader into the slots on the top of the frame. This way, your cards are always protected and can still be displayed. 

This frame stands on its own, but you can also mount it on a wall using two very long screws. Ensure the screws are level and stick out at least an inch from the wall. Then place the frame on top of the screws (see model picture with the three dragon cards). Be careful if you mount it this way. If you push the screws in too far, your frame might not be able to balance and your frame (and cards) can fall. I am working on a variant that is designed for better wall mounting.

Specialized supports are required to print this model. Please ensure you use the settings I have selected in the file. Otherwise, your cards might not slide in nicely. If your cards aren't sliding in, check if there are any support remnants blocking the way. I have optimized the print on the A1 such that cards should slide in and out smoothly. Please let me know if you run into any issues!

Designed in Blender