A1 purge waste bin - minimalist

A1 purge waste bin - minimalist

Boost
33
67
26

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
4.6(23)

Boost
33
67
26
0
154
105
Released

Description

A fast and minimal filament usage purge waste bin, thin walled (0.8mm) so a test of your printers capability as is nearly at max height!

I wanted a fast to print minimal design that fit snugly in with the A1 design, but caught all the purge waste, so here is V1. I'll keep the design updated as improvements are made. Feedback welcome.

Comment & Rating (26)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
I change print, I cut one piece and I have only basket.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fast east print
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bit too small walls, had some warping
The designer has replied
1
Reply
Thanks for the feedback, will be releasing a v2 this week to fix the warping tall wall. Mine has done the same, still functions but not ideal.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
some warping occurred but should work fine
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
adorable
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Top part of the wall was wavy on my print, but love the design. Added some silicon feet to the bottom to keep it in place.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great and works great
1
Reply
Thanks for the simple minimalistic design. Mine printed fine but did warp on the tall wall after a couple of hours because of how thin it is. I don't mind, though, it does it's job!
The designer has replied
0
Reply
Thanks for the feedback! Mine did too a bit, thinking of adding a small ridge on the outside for v2 to try and prevent any warping. Happy Christmas and new year!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Etwas zu kurz bzw. zu nah am Drucker. Filament bleibt so oft an der hohen Außenwand kleben.
0
Reply