Summary

I wanted to hang a paper towel holder on my pegboard. Many of the hangers require that you screw the hanger into the pegboard. I wanted the flexibility of being able to move the hangers where and when I want to so I designed a towel holder that accomplishes that. It is designed for pegboards with 1 inch spacing like those sold by Home Depot and other home improvement centers.

Instructions

Settings (Suggested)
Raft: On
Supports: On
Infill: 35% Suggested to make sure 'pegs' are strong.
Shells: 3
Layer Height: 0.20mm

Print with the arrow on back pointing down towards build plate. Or, with rod opening facing up.

After printing,clean up and remove raft and supports with an xacto knife. Be careful not to damage pegs during cleaning. File as necessary for good fit in pegboard.

I used a 3/4 inch OD piece of conduit but a 3/4 inch wooden dowel rod would be good as well.