Use your basic architect lamp arm to keep your headphone safe ! 

I use to put my headphone on the arm of my desklamp all the time and the skye layer eventually wore out, out of scratching against the thin bars of the connector, have I had this earlier, it wouldve been a different story !

The curvature ambraces the form of any headphones and keep them safe (shake tested) from wearing or falling thanks to a smooth surface and a deep dish design. 

Just clip it onto the triangular connector (prerequisite) of your architect lamp arm and you're good to go 

Note : 

• the model only works with architect lamps with a triangular kind of arm connector, as the two clips are designed for the thin walls of these specific ones. I publish my design because this kind of connector is very common and widely spread enough

   

• Prints without support with the included profile using adaptive layer height. Do not move the model or change the quality settings if you want to print without support.