Couple's Mask for Valentine's Day

Printed with PLA Silk (Pink) and PLA Basic (Black) filaments and I used ribbons to attach the mask. 

In the print profile, I applied special seam painting to the models and set the seam type to contour in the filament settings under the seam section. If your filament seam settings are different, it would be a good idea to adjust them accordingly.

For the female model, I enabled the adaptive layer height setting. You can change it if you'd like, but the model looks better visually with this setting. 

If you're thinking about adjusting the prime tower width, I recommend being cautious. There usually isn't much of an issue with the female mask model, but for the male mask, since the tower is taller, reducing the width could increase the risk of the tower collapsing toward the end of the print.

I also tried printing the masks in a single color. If you'd like a faster print, you can opt for single-color printing.

Happy Printing :)

Instagram | Patreon