Swoopy Poop Chute for Bambu X1, X1C, P1P, P1S Filament Purge Waste with vertical stabilizators
Remixed by
Copyright Claim
Swoopy Poop Chute for Bambu X1, X1C, P1P, P1S Filament Purge Waste with vertical stabilizators
Remixed by
Boost
10
8
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, slowed down
Designer
4.7 h
1 plate
Open in Bambu Studio
Boost
10
8
8
5
49
27
Released
Description
Remix of https://makerworld.com/en/models/93198#profileId-99616 with 2 added vertical flat areas for duct tape/magnets.
I liked the design, but I don't have space to vertically place it behind my printer - it needs to be glued somehow or attached with magnets, so I added vertical areas that shouldn't interfere with anything. Will also improve stability if you decide to duct tape it like I did.
Slow down overhangs, and use large brim - the leg broke at the very layer it should have been merged with the main model for me but it self-stabilized.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)