Cutlery Carrying Case

Cutlery Carrying Case

Boost
18
45
8

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

Original model        0.2mm layer, 2 walls, 15% infill
Original model 0.2mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
5.0(5)

Open in Bambu Studio
Boost
18
45
8
7
47
31
Released

Description

Hello!

 

After breaking a previous cutlery carrying case, I decided to take matters into my own hands and design this version. It features thick 3mm walls in order to withstand any abuse thrown at it. It also features large radii in order to prevent damage from the utensils. The exterior is chamfered to help with printing quality for it to not require supports. 

 

This is a utensil carrying case made with a snap shut lid. For those with keen eyes, you may notice the difference between the model and the printed version. The orange cutlery case was used as a test print for this version. The little tabs added are small handles to assist in opening the box easier. No further modifications were made between the initial version and the final one. The box snaps shut with slight force, and stays shut securely. 

 

I recommend printing this carrying case in PETG, to take advantage of its inherent flexibility versus PLA. PLA also works great (the test print was made from PLA)

 

If anyone has questions or requests, please don't be shy to drop a comment. Some alternative sizes can be made, although this one fits all utensils

 

Thank you!

Comment & Rating (8)

Please fill in your opinion
(0/5000)

Print Profile
Original model 0.2mm layer, 2 walls, 15% infill
Printed for me and my spouse. Can be a little troublesome to open, but this is a minor thing
The designer has replied
1
Reply
Yeah, i noticed that too at first, I was about to change it, but as i kept using it, the snap fit got a bit looser. I hope it has done the same for you. If not, I'll modify it a bit to reduce the snap, thus making it easier to open. Thanks for the feedback!
0
Reply
nice design. I shortened it by about 15% because i'm not planning to put knives in it. The two halves snap nicely together. I printed it in black PETG on a textured plate, looks awesome
The designer has replied
1
Reply
Awesome!
0
Reply
Print Profile
Original model 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Original model 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Original model 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Original model 0.2mm layer, 2 walls, 15% infill
0
Reply
No more