all Dust Cover for P1P, P1S, X1

Remixed by

all Dust Cover for P1P, P1S, X1

Remixed by
Boost
143
398
104

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

ABS Black, 0.16mm layer, 2 walls
ABS Black, 0.16mm layer, 2 walls
Designer
21 min
1 plate
4.7(96)

Open in Bambu Studio
Boost
143
398
104
24
980
800
Released

Description

The best housing covers on a plate for quick printing on a plate.

 

Thanks to @suit, @Grzegorz, @jogu44 and @DodolsAlive for your great work.

Comment & Rating (104)

Please fill in your opinion
(0/5000)

perhaps they have changed the p1s. the plate covers won't fit here. last image: i tried to move the back cover a bit upside but it is not enough space to get the plate in
5
Reply
i think so too, printed this yesterday, but half of it were nowhere to be put
1
Reply
Same here.
0
Reply
Replying to @HomeLifeGA :
I just bought a P1S and printed this and they all fit fine, the only one that was difficult to install was the one at the bottom because you have to push it in so it lifts the plastic back wall up and then it fits fine.
0
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
I printed in white PETG and had some difficulty fitting two of them on my X1C: - the cover on the bottom — really had to push - the cover next to the right Z screw. I had to draw on the top to visualize where the tab was and make a mark to line it up, then push firmly. the left one just slid in.
1
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
Fit good on my P1S
0
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
nice job
0
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
good fit
0
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
goodbye dust.
0
Reply
a couple were tricky to get in. careful on the fan cover. but they're great once in!
0
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
the one that goes on the bottom was a little bit too large for my p1s but arter just filing it down it fit perfectly, great covers.
0
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
I dont know how to remove this :D
0
Reply
Print Profile
ABS Black, 0.16mm layer, 2 walls
1
Reply