Storage box (in place)

Copyright Claim

Storage box (in place)

Boost
584
1243
33

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 10% infill
0.2mm layer, 2 walls, 10% infill
Designer
3.9 h
1 plate
4.8(29)

Open in Bambu Studio
Boost
584
1243
33
20
766
328
Released

Description

Prints in place.

Box dimensions are 100x60mm and height is 55mm (40 for the body + 15 for the lid)

 

The lid looks dirty on the photo, it's just because I tried to sand it to remove supports traces. Unfortunately, my sand paper was dirty :(

Comment & Rating (33)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 10% infill
ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
The Box itself is pretty good. but the latch is incredibly hard to get off. May want to adjust the length by a few millimeters in the future.
The designer has replied
1
Reply
Thanks for the feedback. You can try to adjust the latch axle with a cutter to remove 1 or 2 layer if it's too tight
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
cute, but once it is clasped shut it is REALLY hard to open again.
The designer has replied
0
Reply
One simple solution is to remove a few layers under the latch axle with a little cutter until it's easy enough to open and close
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
turned out great.
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
printed as described, excellent design
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
nice little box!
1
Reply
whats the dimensions of the box?
The designer has replied
0
Reply
oh, I forgot to mention that in the description. Box is 100mm x 60mm, and height is 55mm (40mm for the box + 15mm for the lid)
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply