*New* Boxing Wrap Roller

*New* Boxing Wrap Roller

Boost
26
56
9

Print Profile(3)

All
A1
P1S
P1P
X1 Carbon
X1E
X1
A1 mini

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
3.5 h
1 plate
5.0(4)

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
3.3 h
1 plate
5.0(2)

3-part crank, thick joint - 0.2mm layer, 3 walls, 15% infill
3-part crank, thick joint - 0.2mm layer, 3 walls, 15% infill
3.1 h
1 plate

Open in Bambu Studio
Boost
26
56
9
16
113
82
Released

Description

* THIS IS THE NEW & UPDATED OF THE OLD BOXING WRAP *

-whats new-

  • overall larger housing
  • stronger spindle that doesn't pinch the band
  • flange that holds the spindle in place (no more friction fit) 

 

Boxing wrap roller

  • supports up to 180in wraps
  • pressure plate to flatten wrap

 This is a boxing wrap roller designed by me on CAD, this version uses a flange that needs to be glued in place 

(place two small lines of glue on the bottom of the shaft, slide the flange down and hold in place for a few seconds flush against the body, rotate the shaft once in a while so it doesn't get glued to the housing)  

once fitting together feed the Velcro or loop end of your strap through the slit in the shaft, then through the small slit and then in and through the pressure plate (see pictures above). large gap should be facing down when you are winding the wrap up. then simple pull the wrap off the shaft. Enjoy! always open to feedback and suggestions 

 

also print orientation changed for the handle and provides a much cleaner finish, i have had a little trouble with the supports but think its working well now, if one of the halves of the shaft comes loose you can paint a little more support on 

 

 

Comment & Rating (9)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 15% infill
Turned out wonderful!!! No need for supports. Thank you both for the original and the remix. :)
2
Reply
you’re welcome! thanks for printing it
0
Reply
Boosted
Good design! The designer profile is great but I got a lot of dents on the shaft which caused by the support. To overcome this, I cut the handle into 2 parts so I can print without supports and it looks smoother and cleaner.
(Edited)
2
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
works great! I adjusted the supports a bit, but overall it’s a great model. my wraps are fully wrapped in seconds and it makes sure there are no creases or folds. awesome
The designer has replied
0
Reply
how did you adjust the print orientation??? I’ve had some issues with the spindle because of the fan
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed great with PETG HF!
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
fantastic & keeps the wraps from tangling
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more