Full squid game guards mask set

Remixed by

Full squid game guards mask set

Remixed by
Boost
80
114
23

Print Profile(2)

All
P1P
P1S
X1
X1 Carbon
X1E
A1
A1 mini

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
31.1 h
11 plates
4.8(4)

0.16mm layer, 2 walls, 15% infill for A1 mini
0.16mm layer, 2 walls, 15% infill for A1 mini
Designer
34.1 h
11 plates
5.0(2)

Open in Bambu Studio
Boost
80
114
23
16
199
64
Released

Description

Content has been automatically translated.
Show original

This is a remixed model incorporating three distinct Thingiverse designs, offering a selection of printable components.

Assembly:

https://youtu.be/NjC--Ux0p0Y

1 Hang the bottom section onto both hooks of the top section
2 Insert the projection into the central rail
3 Secure the stopper to prevent component detachment after insertion

[Assembly Instructions]

Hang the bottom piece onto the hooks on either side of the top piece
Insert the projection into the central rail
After inserting the stopper, weld or apply glue to prevent parts from falling out
top_ver2.stl presents a thinner mesh for enhanced visibility, though this may slightly compromise durability

Boost Me (for free)

Comment & Rating (23)

Please fill in your opinion
(0/5000)

Print Profile
0.16mm layer, 2 walls, 15% infill
Everything's fine
The designer has replied
1
Reply
Perfect!
0
Reply
the only thing that I don’t like is that it is really hard to put together
The designer has replied
0
Reply
Really? I find it quite simple. did you watch the video in the description?
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
love it
The designer has replied
0
Reply
May I ask for why the last star isn’t there?
0
Reply
Replying to @Mayomate77 :
the two pieces fell apart a couple times
0
Reply
Replying to @user_78818579 :
I apologize for those failures, however they are normally caused with bed adhesion failure?? This isn’t a model problem.
0
Reply
this is the best mask ever thank you so much bro 👍
The designer has replied
1
Reply
You’re welcome
0
Reply
BRILLIANT
The designer has replied
1
Reply
Awesome! Thanks for the boost!
0
Reply
do you need glue the assemble
The designer has replied
0
Reply
Glue is required for gluing the stopper to the bottom part. The video will guide you too.
0
Reply
Nice model! It also looks like someone else is trying to claim these on here
The designer has replied
0
Reply
What do you mean in terms of claim?
0
Reply
why is the top part printed at an angle instead of flat?
The designer has replied
0
Reply
It is for model surface quality, if it were to be printed flat, there would be more supports needed and top surface quality wouldn’t be as good as the current print orientation.
0
Reply
I want to know where the maker find that kind of buckle for the mask. I looked everywhere and can't find some like that, I even went online and nothing.
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply