SpiderPunk Hueforge.

Color changes are all set up in the file. It uses a total of 5 colors. If you don't have 2 or more AMS units, you'll need to do a manual swap for the final (white) layer.

Alternatively, entire print can be done with manual swaps if you have no AMS - all colors print sequentially in the order listed below starting with yellow. To get this exact look, these are the filaments I used but close aproximations should be fine with only the yellow/pink overlap that produce the specific red being a bit of a concern. Using a straight red is likely to produce an orange color:

Yellow: ZIRO High Speed Yellow PLA

Pink (to get the red): ZIRO High Speed Magenta PLA

Black: 3DHojor High Speed Black PLA 

Blue: 3DHoJor Silk Blue Purple Dual Color PLA

White: 3DHoJor High Speed White PLA