hope it works good for you! Its still a work in progress and can be changed with peoples input and suggestions. certain parts were printed in certain orientations for dimensions and strength. my printer over here is abit finnicky with dimensions and prints

hey! thanks for the comment. Parts List: Bolt Kit/Screws Carrier Bearing - https://www.amazon.ca/gp/product/B0C74V3FF2?ie=UTF8&;th=1 Carrier Bearing Shaft - https://www.amazon.ca/gp/product/B0BM452GDR?ie=UTF8&;psc=1 The "Carrier Bearing" can be the shaft from a transmission and the two bearings, but the problem with using the transmission shaft is it has a gear pressed onto it that i never managed to figure out how to remove. Pancake style motor - https://www.amazon.ca/gp/product/B0D9QB39WD?ie=UTF8&;th=1 any motor may work, I assume a brushed motor would stick out weirdly with such a large skid angle and potentially hit the rear links/driveshaft Links - used 50mm bent brass links on the lower front. I can happily upload stronger and different length links for the front so people can try different options. Driveshafts - https://www.amazon.ca/gp/product/B09DPPJYYX/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&;psc=1 Deadbolt front driveshaft as the rear driveshaft. I believe gladiator rear driveshaft as the most rear driveshaft. but might be forgetting as it was a bit finnicky to get the 50mm rear shocks to work with a driveshaft front driveshaft is from a c10 front driveshaft. but other lengths can work with different front link lengths. Shocks are front 40mm big bore - https://www.amazon.ca/gp/product/B0D9B2QZLP?ie=UTF8&;psc=1 and 50mm double barrels in the rear. id assume it works good with 40mm in the rear too just haven't had time to test and refine the design. love any input and suggestions! have fun printing and crawling

great to hear! if you need anything changed like holes sizes or what not let me know and I can change it for ya. have fun!