I have looked at about 70 desk organizers in the last week and decided that I would just make my own. I printed it in three pieces due to size limitations and ease of printing. Settings I used were 218ºC for the nozzle and 65ºC for the bed. I get a lot of warping in the base if I don't use a brim. With that said, I had to trim the brim off post print with an Xacto. This is my first upload so you guys please let me know what you think.
Printer:
Klic-N-Print 3D
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.4mm
Infill:
Honeycomb 10%
Comment & Rating (0)