French Cleat Tape Holder by Filament Mason

Filament Mason

Tools>Organizers

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 5 walls, 50% infill

Designer

9.3 h

2 plates

5.0(1)

Open in Bambu Studio

Boost

116

Released

Description

These are brackets meant for ¾" french cleats that work with ¾" rods (yeah, that's right, imperial).

The middle bracket allows for a third shorter rod to also hold smaller tape rolls. It is not a requirement.

These have worked with 32" aluminum rods (left over deck railing balusters) with no problem or sagging with PLA. They have a snug fit with no glue necessary.

woodworking

french cleat

tape holder

Comment & Rating (3)

@Two_Trees

Print Profile

0.2mm layer, 5 walls, 50% infill

Printed great. The deck rods were kinda expensive to buy since you have to buy so many at a time. I used a dowel rod and had to add a single wrap of double-sided tape, but then it worked great.