really liking this so far. I have gridfinity set up in my kitchen drawers already, so I'm loving the fact that the trays I built there seem to work height wise here already. Liking that different size boxes are coming. Making me wish I had multiple printers to do multiple plates at a time.

works very nice, I like the flexibility of the box dividers... more flexibility. Printed with a second color in the top 5 MM to match other prints.

printing out an entire drawer of various gridfinity organization. added a color change to match what I’d printed already.

I seem to have too many straws, and maybe I should have printed this with higher walls. But looks good in my drawer anyway :)

of my recent prints, I think this is my wife’s favorite. works great. adjusted the size for some mugs we had and still printed great

has improved my battery storage immensely. awesome

starting my gridfinity journey i guess. really like these bins. I might reprint to add depth as there is lots of room in the drawer. or maybe stack them two high. love the two tone look.

Looks good. Reminder right now of how little I've been on my bike lately, but this looks great hanging up in my office.

Little smaller than I expected... I need to stop assuming what I see and review the sizes before I print. Lesson for me :D Still, I love how it turned out in black with the brown exterior... Looks great. Plan to print again possibly at 200%. Will need to figure out if increasing the ratio will impact on the fit later.

printed nicely and added to my golf bag

printed a bunch of these to toss in my bag. work great.

fun print. like that the drawers are deep.

printed great. sorta surprised me how long some of the parts took to print. but I’ve only been doing this a few months. kitchen is being redone this week, so this is prepped for after the work is done. love it.

quick clean print that fits great

need to figure out the mounting screws as they are long gone, but these seem to work well. I printed 4 and added a negative space to allow the power cable to pass through when mounted vertically.

Looks great. Love how it looks in the bathroom. Could use some supports on the overhang on the base part, but the overlay covers the very slight droop. Bambu Studio did warn me of the missing supports, but I was starting the print in a rush, and ignored it. That was the no AMS config.

I did not do a perfect job lining up the top and bottom parts when I glued them. but worked out okay. using this as a token in a game Called Ark Nova so it works pretty good there.

great token trays for board games. quick prints. did 4 colors just in case. (only 3 in the picture)

Really like this, I have printed out the bumpers in red tpu to match the highlights in my truck. Think the red on black looks very smart. I have the 1L Yeti water bottle (I think it's that size) and it's a little small in the hole. So maybe I'll reprint the bumpers but make them a little taller each to keep them from bumping around in there. Seems to sit nicely in the console despite not being held down. In my RAM, there is a cubby on the LHS under where the phones sit, possible anchor point

Looks great, my son loves it. Took over 3 days to print, including a couple issues along the way that thankfully everything recovered from. In an attempt to save some filament, I selected purge to infill, but you can see some of the colors behind both Venom and Spidey's eyes. Figure that's easy to fix with some white paint though and saved 300+ grams of filament. There's a little swirl on spidey from the print, going to a little sandpaper to it. Love It!