RbeforeE

0.16mm layer, 4 walls, 100% infill

RESIST mini key fob - 50 pack

0.28mm layer, 2 walls, 15% infill

Bless Your Boney lil Head Tissue Box Cover

0.28mm layer, 2 walls, 15% infill, Concent Top

Small Paint holder with dovetail joint - A1M 12+3

This printed without a problem. I was able to place the stem and leaf base on the bed together to save time too. There was a little bit of clean up from the support but not much since it is an organic shape. I easily trimmed the stem down with scissors so I could use a shorter vase. 

besnia_darvar

Beautiful Roses

Stem, 0.16mm layer, 2 walls, 10% infill

This printed easily on my A1 Mini. I used Bambu Lab PLA Basic Red and Basic Green and it really is lovely. 

The stem screwed on without a problem. I did lose a teensy bit of a leaf tip while removing supports, so I advise being conscientiously patient and attentive during post. Fortunately since it is an organic shape there was no problem. I just snipped the piece the rest of the way clear and no one is the wiser. 

Thanks for the excellent model. 

Rose, 0.16mm layer, 3 walls, 10% infill

This is a great tool for folks who cannot hold the shoe horn while slipping the shoe on! I did need to tweak the design to make the clip accommodate a thicker shoe back since the prescription diabetic shoe I was making it for has a lot of padding to prevent sores. That process made me truly appreciate the complexity of this design with the multiple curves in different directions. This is like a Pringles chip on steroids when it comes to curves. I am really impressed with the engineering. Thanks!

Stag 3D

Quick-Slip Shoe Horn

0.2mm layer, 2 walls, 15% infill for a1mini ,single

It printed without a hitch. now I just need to learn what to do with the results. lol

hectorri

Calibration cube XYZ