Printed using PLA. It works fine. Great model.

This is great idea.

This is really excellent project as mentioned in another evaluation comment. Just one thing was load-cell screw hole pitch is vary in the market.

Printed using ABS but 100 degree C. temp. build plate. Used support filament for ABS too. Have not changed scale. Used just 100% It works fine. Currently all spools in AMS are more than 70%. Looking forward to seeing its effect when filament became less than 20-30% remaining.

Printed using ASA. I have put P1S logo with ABS orange. I don't have enough time and printing to evaluate the duct efficiency.

Printed using ASA Ivory and ABS Orange for text. Printed well.

Printed using PLA. Have made scaling up to fit Handy Cleaner handle. The Cleaner cannot stand up by itself. This holder is perfect, easy fix and pull handle. Just made base to fix holder at handle of cabinet door.

Printed using Bambu ABS with 0.16mm layer height and Support for ABS filament. Will try it later. It looks great.

Printed using Bambu ABS. It works well.

Printed using ABS with 2.5% upscale for future upgrade of my AMS. Put brim just in case.

It works at moment. I have used shorter one in my setup.

Great. It is strong enough.

It works well.

Have printed using translucent filament. It works fine.

It works well.

Have printed using ASA. It is bit tight to install but it works well.

It worked well. Very handy.

It worked greatly and I made some remix so that I can slide glass to adjust amount of alr while keeping original designate glass holder. I have printed using translucent filament. It made lighting effect to outside as expected. I appreciate original designer to upload excellent model.

It is very good. Have printed using Blue PLA at first but it made LED light hidden. Therefore, changed material to PETG white translucent. Result is shown in this picture. I have satisfied this result.

works well