Works great too!

This model needs a more tighter tolerance lid.

Functional, but depending on your material choice and characteristics (shrinkage) it may not fit as tightly (during usage) as you'd like. I used PETG. Stars are based on that only, not the issue below. Also the supports were a PITA to remove... This alone would drive me to another solution. You can just toggle PLA supports.

Character is on a layer of its own. Would have liked if it was flat, by embedding into the top layer with material surrounding it.

Few pieces broke very early on. There are other models with more strength.

It somewhat works. The tolerance between drop and OFF is quite minimal so careful when turning.

Works great, tight tolerance! Warning: scaling the model will require rework of the threads.

Functional. However note that in a car it will probably rattle a bit (the lid). I used tape on parts where there is contact. You could also use some hot glue to tighten the tolerance a tad.

Works, a quality model. Scaling also works perfectly.

We needed this. Prints great, correct orientation during print too, for a quality look.

Unless you KNOW your glasses are smaller than normal just print the large one.

Works great.

These worked great, had them outside to during a heat wave of 38 C. Plants survived. Used PETG.

Came out great, and I was able to customize it!

If you iron, you need this.

It works, though I did have a defect. Not sure if it was inherent in the design. If I have time to retest I let you know.

Slim design that works with my limited shelf space.

Came out great.

If you have a Kitchenaid, you've broken this piece.

Great design. Stars are based on that only, not the issue below. Model is not kid safe as there are sharp pointed edges.